6
RETRO KETTLE
KH 1025
RETRO KETTLE
Operating instructions
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
ID-Nr.: KH1025-05/08-V2
INDEX
PAGE
Intended use
2
2
2
2
3
3
3
4
4
5
5
Technical Data
Safety information
Operating Elements
Commissioning
Boiling water
Cleaning and Care
Storage
Disposal
Warranty and Service
Importer
Read these operating instructions carefully before using the appliance for the first time and preserve this booklet
for later reference. Pass this booklet on to whoever might acquire the appliance at a future date.
- 1 -
RETRO KETTLE KH 1025
• Always remove the plug from the power socket
after use. Simply switching the appliance off is
not sufficient, as the appliance is under power
for as long as the plug is connected to the socket.
Intended use
This appliance is intended for the boiling-up of
water in domestic households. It is not intended for
use with other liquids or for commercial use.
ƽ To avoid burns and other injuries:
• Always heat water with the lid on, otherwise the
automatic switch-off does not function correctly.
Boiling water could then spray out over the rim.
• Hot steam clouds may be released. Additionally,
the kettle becomes very hot during use. Wear
oven mitts.
Technical Data
Voltage :
Power consumption :2200 W
220 - 240 V / 50 Hz
• Ensure that the appliance is standing securely
and vertically before switching it on.
~
Boiling water can cause an unstable kettle to fall
over.
ꢀ In older electrical installations, the building fuse
(12A) may be triggered due to the high power
consumption.
• This appliance is not intended for use by indivi-
duals (including children) with restricted physical,
physiological or intellectual abilities or deficiences
in experience and/or knowledge unless they are
supervised by a person responsible for their safety
or receive from this person instruction in how the
appliance is to be used.
Safety information
To avoid potentially fatal injury
through electric shock:
• Children should be supervised to ensure that
they do not play with the appliance.
• Ensure that the base with the electrical connec-
tions does not come into contact with water! If it
has unintentionally come into contact with water, Operating Elements
first allow it to dry out completely before taking it
into use.
Handle
Lid with knob
Scale
ON/OFF switch with integrated control lamps
Base
Pourer-sieve
q
w
e
r
t
y
• Only use the water boiler with the supplied
base.
• Ensure that the power cable never becomes wet
or damp during operation. Lay the cable so that
it cannot be trapped or otherwise damaged.
• To reduce the risk of injury, arrange for defective
power plugs and/or cables to be replaced at
once by qualified technicians or our Customer
Service Department.
- 2 -
Commissioning
– at least to the MIN mark, so that the appliance
does not overheat,
• Before taking the appliance into use, ensure that ...
– no higher than the MAX mark, so that no boiling
water spills out.
-
the appliance, plug and power cable are in
good working order and...
• First close the lid ...
w
– all packaging materials have been removed
from the appliance.
• and then place the kettle on the base
such
t
that it is standing absolutely upright on the base
.
t
• Fill the appliance up to the MAX marking on
• Now insert the power plug into the power socket ...
the scale
with a water and vinegar mixture
• and press the ON/OFF switch
it engages.
upwards until
e
r
having a mix-ratio of 6:1 and then bring it to
be boil – as described in the next section.
• The control lamps integrated into the ON/OFF
switch indicate that the appliance is now
r
ƽ Warning
heating the water up.
• The appliance switches itself off and the control
Do not inhale the vapours escaping during the boiling
process! This could lead to irritation of the mucous
membranes and an indisposition.
lamps go out as soon as the water is on the boil.
The ON/OFF switch
springs down.
r
• When the process is finished, pour the water-
vinegar mixture away.
ƽ Warning
Remove the plug from the wall socket before you lift
• Rinse the kettle out with clear water.
• Fill the appliance with water up to the MAX
the kettle from its base . This prevents causing a
potential short circuit by water possibly spilling out
t
marking on the scale
and then bring it to be
of the carafe and falling onto live electrical connec-
e
boil. When done, pour it away also.
tions in the base
.
t
ƽ Injury hazard
Boiling water
For safety reasons, the lid
should not be opened
w
while the water is boiling or is very hot. There is a
risk of receiving severe scalds.
ƽ Danger
Never place the electrical base
life-threatening danger!
near water –
t
Cleaning and Care
• Lift the kettle off of the base when filling it!
• Remove the lid in that you pull it upwards.
• Hold the kettle upright while filling it. Only in this
ƽ Danger
w
Do not open any part of the housing. There are no
user-servicable elements inside. An open housing
can create the risk of a lethal electrical shock.
way can you correctly read the markings on the
scale
.
e
Fill the kettle ...
- 3 -
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered com-
ponents.
ꢀNote
Should the scale deposits in the pourer-sieve
be
y
firmly settled, lay it in a water-vinegar solution, with
a ratio of 6:1, for a few hours. The scale deposits
will dissolve themselves. Rinse the pourer sieve
with lots of clear water.
y
Before cleaning the appliance, ....
• first, remove the plug from the power socket and
allow the appliance to cool down completely.
• Clean the exterior surfaces and the power cable
with a slighly damp cloth. Be sure to dry the
appliance well before taking it back into use.
• Never use detergents, abrasive cleaners or
solvents. These can damage the appliance.
Storage
Allow the appliance to cool down completely
before putting it into storage.
• Wind the power cable around the holder on
the bottom of the appliance.
• Store the appliance in a dry place.
In the event of scale deposits:
• Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in
the instructions provided for the use of the de-
calcfying agent.
Disposal
Do not dispose of the appliance in
your normal domestic waste.
Removing/replacing the pouring sieve
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
• Take the lid
off.
w
• Press the flap on the pourer-sieve
down and
y
pull it inwards. Remove it from the kettle.
• Clean the pourer-sieve with a lightly moistened
y
dish cloth.
• After cleaning it, replace the pourer-sieve
:
Dispose of the packaging materials in an
environmentally responsible manner.
y
Take hold of it by the flap, then position the lower
lug, from the inside, into the lower recess inside
the pourer. Then press the upper lug into the
recess until the pourer-sieve
is sitting firmly.
y
- 4 -
Warranty and Service
Importer
You receive a 3-year warranty for this appliance as
of the purchase date. The appliance has been manu-
factured with care and meticulously examined be-
fore delivery. Please retain your receipt as proof of
purchase. In the case of a warranty claim, please
make contact by telephone with our service depart-
ment. Only in this way can a post-free despatch for
your goods be assured.
KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM / DEUTSCHLAND
The warranty covers only claims for material and
maufacturing defects, not for worn parts or for da-
mage to fragile components, e.g. buttons or batte-
ries. This product is for private use only and is not
intended for commercial use.
If this product has been subjected to improper or in-
appropriate handling, abuse, or modifications not
carried out by one of our authorised sales and service
outlets, the warranty will be considered void. Your
statutory rights are not restricted in any way by this
warranty.
DES Ltd
Units 14-15
Bilston Industrial Estate
Oxford Street
Bilston
WV14 7EG
Tel.: 0870/787-6177
Fax: 0870/787-6168
e-mail: [email protected]
Irish Connection
Harbour view
Howth
Co. Dublin
Tel: 00353 (0) 87 99 62 077
Fax: 00353 18398056
e-mail: [email protected]
- 5 -
|