JVC TV Converter Box KA F5604U User Manual

Analog output card  
INSTRUCTIONS  
KA-F5604U  
COMP/VBS OUT  
This instructions book is made from 100%  
recycled paper.  
For Customer Use:  
Enter below the Serial No. which is  
located on the body. Retain this  
information for future reference.  
Thank you for purchasing this JVC product.  
Before operating this unit, please read the  
instructions carefully to ensure the best  
possible performance.  
Model No. KA-F5604U  
Serial No.  
LWT0272-001A  
 
SAFETY PRECAUTIONS (FOR USA AND CANADA)  
CAUTION  
ATTENTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
RISQUE D’ELECTROCUTION  
NE PAS OUVRIR  
ATTENTION: POUR EVITER TOUT RISQUE D’ELECTROCUTION  
NE PAS OUVRIR LE BOITER.  
AUCUNE PIECE INTERIEURE N’EST  
A REGLER PAR L’UTILISATEUR.  
SE REFERER A UN AGENT QUALIFIE EN CAS DE PROBLEME.  
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,  
DO NOT REMOVE COVER (OR BACK).  
NO USER-SERVICEABLE PARTS INSIDE.  
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL  
Le symbole de l’éclair à l’intérieur d’un triangle  
équilatéral est destiné à alerter l’utilisateur sur la  
présence d’une “tension dangereuse” non isolée  
dansleboîtierduproduit.Cettetensionestsuffisante  
pour provoquer l’électrocution de personnes.  
The lightning flash with arrowhead symbol, within an  
equilateraltriangle, isintendedtoalerttheusertothe  
presence of uninsulated “dangerous voltage” within  
the product’s enclosure that may be of sufficient  
magnitude to constitute a risk of electric shock to  
persons.  
Le point d’exclamation à l’intérieur d’un triangle  
équilatéral est destiné à alerter l’utilisateur sur la  
présence d’opérations d’entretien importantes au  
sujet desquelles des renseignements se trouvent  
dans le manuel d’instructions.  
Theexclamationpointwithinanequilateraltriangleis  
intendedtoalerttheusertothepresenceofimportant  
operating and maintenance (servicing) instructions  
in the literature accompanying the appliance.  
*Ces symboles ne sont utilisés qu’aux Etats-Unis.  
WARNING:  
AVERTISSEMENT:  
TO REDUCE THE RISK OF FIRE OR  
ELECTRIC SHOCK, DO NOT EXPOSE THIS  
APPLIANCE TO RAIN OR MOISTURE.  
POUR EVITER LES RISQUES D’INCENDIE  
OU D’ELECTROCUTION, NE PAS  
EXPOSER L’APPAREIL A L’HUMIDITE OU  
A LA PLUIE.  
This unit should be used with 12 V DC only.  
CAUTION:  
Cet appareil ne doit être utilisé sur 12 V en  
courant continu.  
To prevent electric shocks and fire hazards, DO  
NOT use any other power source.  
ATTENTION:  
Afin d’éviter tout resque d’incendie ou  
d’électrocution, ne pas utiliser d’autres  
sources d’alimentation électrique.  
NOTE:  
The rating plate (serial number plate) is on this unit.  
INFORMATION  
REMARQUE:  
La plaque d’identification (numéro de série) se  
trouve sur la partie inférieure de l’appareil.  
This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant to  
Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful  
interference in a residential installation. This equipment  
generates, uses, and can radiate radio frequency energy  
and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that  
interference will not occur in a particular installation.  
If this equipment does cause harmful interference to  
radio or television reception, which can be determined  
by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or  
more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit  
different from that to which the receiver is connected.  
Consult the dealer or an experienced radio/TV  
technician for help.  
CAUTION  
INFORMATION (FOR CANADA)  
RENSEIGNEMENT (POUR CANADA)  
CHANGES OR MODIFICATIONS NOT APPROVED  
BY JVC COULD VOID USER’S AUTHORITY TO  
OPERATE THE EQUIPMENT.  
This Class B digital apparatus complies with  
Canadian ICES-003.  
THIS DEVICE COMPLIES WITH PART 15 OF THE  
FCC RULES. OPERATION IS SUBJECT TO THE  
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE  
MAY NOT CAUSE HARMFUL INTERFERENCE, AND  
(2) THIS DEVICE MUST ACCEPT ANY INTERFER-  
ENCE RECEIVED, INCLUDING INTERFERENCE  
THAT MAY CAUSE UNDESIRED OPERATION.  
Cet appareil numérique de la Class B est  
conforme à la norme NMB-003 du Canada.  
3
 
SAFETY PRECAUTIONS (FOR EUROPE)  
WARNING:  
TO REDUCE THE RISK OF FIRE OR ELECTRIC  
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO  
RAIN OR MOISTURE.  
This unit should be used with 12 V DC only.  
CAUTION:  
To prevent electric shocks and fire hazards, do  
NOT use any other power source.  
Note:  
The rating plate (serial number plate) is on this unit.  
CAUTION  
To prevent electric shock, do not open the cabinet. No user  
serviceable parts inside. Refer servicing to qualified service  
personnel.  
This equipment is in conformity with the provisions and protection requirements of the corre-  
sponding European Directives.This equipment is designed for professional video appliances  
and can be used in the following environments:  
5 Residential (including both of the location type class 1 and 2 found in IEC 1000-2-5)  
5 Commercial and light industrial (including, for example, theatres)  
5 Urban outdoors (based on the definition of location type class 6 in IEC 1000-2-5)  
This apparatus is designed for rack mounting or is used close to other apparatus.  
In order to keep the best performance and furthermore for electromagnetic compatibility we  
recommend to use cables not exceeding the following lengths:  
Port  
Cable  
Length  
COMP/ VBS OUT  
Shielded Twist Pair Cable  
less than 2 m  
Caution:  
5 Where there are strong electromagnetic waves or magnetism, for example near a radio or  
TV transmitter, transformer, motor, etc., the picture may be disturbed.  
In such a case, please keep the apparatus away from the sources of the disturbance.  
4
 
Thank you for purchasing the KA-F5604U Analog output card.  
By inserting this card into JVC’s color video camera  
KY-F560, either composite video signal, component  
video signal(Y/Cb/Cr), RGB signal or Y/C signal is  
output.  
COMP/VBS OUT  
Analog output  
terminal  
Mounting this card to KY-F560 Camera  
KY-F560  
KY-F560 power must be switched off before mounting  
the card.  
1. Remove two screws Å from the rear of the camera and  
take out the slot cover.  
Screw Å  
Slot cover  
KY-F560  
2. Insert this Analog output card into the slot at the rear of  
This card  
the camera and secure it by screwing back the two  
screws Å which were taken out earlier in the above  
mentioned step 1..  
COMP/VBS OUT  
Slot  
Notes  
Analog output  
Ensure that the Analog output card is inserted  
terminal  
all the way in.  
Screw Å  
5
 
Description of Terminals  
Notes  
Analog Output Terminal (D-sub 9PIN,  
Female)  
Cannot be connected to computer monitor.  
The output signal could be selected using  
the “OUTPUT” item under the “SYSTEM”  
menu screen on the KY-F560.(page 7)  
5
1
9
6
Pin No.  
RGB output  
GND  
GND  
R OUT  
G OUT  
B OUT  
Y/C output  
Y/Cb/Cr output  
GND  
GND  
Cr OUT  
Y OUT  
Cb OUT  
Composite video OUT  
-
1
2
3
4
5
6
7
8
9
GND  
GND  
-
Y OUT  
C OUT  
Composite video OUT Composite video OUT  
-
-
GND  
GND  
GND  
GND  
GND  
GND  
Connection  
[ Connection example ]  
When connecting  
Perform this when the devices are off.  
Read the instruction manual of the unit before preforming it.  
Color video camera  
KY-F560  
Analog output card  
KA-F5604U  
D-sub 9pin (2m)  
COLOR VIDEO CAMERA KY-F560  
Monitor  
Notes  
Please make sure to the cable with outer shield when connecting the D-sub cable.  
The screw section for mounting D-sub cable of this unit is mm specification.  
When using inch type D-sub cable, change to the supplied inch type screws.  
6
 
Menu Screen  
When KY-F560 camera is mounted on this unit, new menu screens and menu items are  
appeared on the screen.  
The additional new menu screens and menu items will be explained here.  
Please refer to KY-F560 instruction manual for details on menu screen setting.  
“SYSTEM” Menu Screen  
The following additional items are added to the “SYSTEM” menu screen.  
The settings in bold are factory settings.  
Item  
OUTPUT  
Function/Variables  
From Analog output terminal, besides the composite signal, an-  
other type of output video signal could be output. The additional  
output signal is selected here.  
Y/Cb/Cr”  
“RGB”  
: Y/Cb/Cr component signal will be output.  
: RGB component signal will be output will embed-  
ded sync signal.  
“Y/C”  
: YC separate signal will be output.  
“DISPLAY” Menu Screen  
“DISPLAY” menu will be appeared, but not for this unit.  
7
 
Specifications  
Analog Output  
: Composite video signal  
Component signal  
(Either Y/Cb/Cr,RGB or YC separate output signal could be selected)  
: Supplied by camera  
Power supply  
Power consumption  
: 9.6 W (Include KY-F560 camera)  
Operating temperature range : -5 °C to 40 °C (Humidity below 80 %)  
Dimensions  
Weight  
: (W) 22.4 mm x (H) 70.2 mm x (D) 76.5 mm (Exclude protruded part)  
: 60 g  
Accessories and attachments : Instruction Manual  
Screws (Inch type) x 2  
Dimensions ( unit : mm )  
76.5  
71  
22.4  
COMP/VBS OUT  
Specification and appearance of this unit are subject to change for further improvement  
without prior notice.  
is a registered trademark owned by Victor Company of Japan, Limited.  
is a registered trademark in Japan, the U.S.A., the U.K. and many other countries.  
Printed in Japan  
LWT0272-001A  
© 2005 Victor Company of Japan, Limited  
 

Infinity TV Mount FMK 1 User Manual
InStep Stroller SB100 User Manual
Invacare Wheelchair 1114851 User Manual
IOGear Computer Drive GHE835C User Manual
Jenn Air Refrigerator W10735232A User Manual
Kenmore Dishwasher 9743678 User Manual
Kenwood Marine Radio TK 7102 User Manual
Keys Fitness Treadmill ALL800 User Manual
Kompernass Coffeemaker SKAD 1000 A1 User Manual
Konica Minolta Camera Accessories T 10A T 10MA T 10WSA T 10WLA User Manual